Sustainable Operation Management Assignment Example | Topics and Well Written Essays - 2500 words

Sustainable Operation Management - Assignment Example According to Appleby (2013) this basically not only deal with supply chain and the introduction of raw materials but also the wider development and design of processes as well as waste disposal, this also deals with the incorporation of lifecycle analysis focused on ensuring that sustainability efforts is inclusive in all the processes (Appleby 2013). Sustainable practices within organizations must be developed to ensure the reduction of carbon footprint throughout the specific targeted processes in the organization. Sustainable operations management is evident in many in order to achieve the desired outcome. REFILLING WATER IN SWIMMING POOL IN SPORT HALL Sport swimming pools sometimes need to be completely drained and then refilled. Pre-balanced water is usually needed to be refilled directly into the empty pool. It is important to identify effective and efficient process of refilling and maintaining the swimming pool to meet the set standards for sports. Therefore preventive swimmi ng pool practices should be adopted in this process in order to save time as well as costs. Boosting the efficiency of the sports swimming pool is very important in reducing the underlying carbon footprint facilitating achieving sustainable lifestyle (Finkbeiner 2009). The process of refilling the sports swimming pool to achieve sustainability there has to be energy conservation, water and the chemicals at the pool. Increased carbon footprint at the pool leads to a great dent on the environment. An overview of sustainable operations management concerning swimming pool water refilling is to facilitate environmentally labeled â€Å"Green Home† swimming pool more concern put on pool evaporation, reduced carbon footprint and long term sustainability (Finkbeiner 2009). The following is the processes that are followed to achieve sustainable operations management in refilling water in swimming pool. Cleaning the swimming pool This is mainly the first step after the pool has been dri ed out. The surface composition needs to be determined. These basic procedures enhance efficiency and save a lot of time. Deck and cover cleaning is a common method which facilitates removal of debris and spa deck. A quick sweep facilitates removal of debris near the swimming pool. In conducting this process care should be taken to avoid abrasive surfaces while dragging the cover off the pool. Surface skimming is applied in removing dirt floating on the surface. It is remembered to empty skimming debris into the lawn so that it does not blowback into the pool when it dries up. Tile brush and tile soap to clean the tiles and this is done below and above the waterline. It is notable that evaporation and refilling of the swimming pool usually changes the waterline. Brushing is the most efficient way of removing algae from the surfaces and directing the dirt to the main drain so that it can be sucked in the filter (Appleby 2013). It is important to clean the filter and run fresh water i n the circulation system to purge away all the dirt from the lines. The general effective and efficient process in carryout this is to drain, clean and to refill the swimming pool. Refilling the swimming pool The pool is filled direct in the sunlight in cases where it is filled above the ground. The direct sunlight facilitates stretching of the liner as the pools fills. The spigot is turned on